Compex SCSI TO S-ATA RAID Podręcznik Użytkownika Pobierz pdf (Strona 43)

Chapter 7: Installing the Driver and an Operating System ● 43

Installing with Windows

Note: You will need your Windows installation CD to complete this task.

To install the Adaptec RAID controller driver while installing Windows:

1 Insert your Windows CD, then restart the computer.

2 Follow the on-screen instructions to begin the Windows installation.

3 When prompted to install a third-party driver, press F6.

Note:

When F6 is active, a prompt appears at the bottom of the screen for only 5 seconds.

If you miss your chance to press F6, restart your computer.

Insert the driver disk, then wait until you are prompted to install a driver.

5 Press S to specify that the driver is on a floppy disk, then press Enter.

The computer reads the disk.

6 When the Adaptec driver is found, press Enter.

7 Follow the on-screen instructions to complete the installation.

8 Continue with Managing Your Storage Space on page 52.

Installing with Red Hat Linux

Note: You will need your Red Hat installation CD to complete this task.

To install the Adaptec RAID controller driver while installing Red Hat Linux:

1 Insert the first Red Hat installation CD.

2 Restart your computer.

3 When the Red Hat Welcome screen appears, type

linux dd

at the Boot: prompt.

4 When prompted, insert the driver disk, then select OK.

5 Follow the prompts to set up the environment you want.

6 If you are installing other third-party devices, install them now. Otherwise, select Done.

7 Complete the Linux installation, following the instructions included with your operating

system.

8 Continue with Managing Your Storage Space on page 52.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 108 109

Brak uwag

Compex SCSI TO S-ATA RAID Podręcznik Użytkownika Strona 43